Ford Focus Service Manual: Anti-Lock Brake System (ABS) Module

Ford Focus Service Manual / Chassis / Brake Control and Vehicle Dynamics / Dynamics Control / Anti-Lock Brake System (ABS) Module

Special Tool(s)

Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool

Item	Part Number	Description
1	2C286	Hydraulic Control Unit (HCU)
2	2M101	ABS module screws (4 required)
3	2C013	ABS module

Removal and Installation

Remove the Hydraulic Control Unit (HCU) . For additional information, refer to Hydraulic Control Unit (HCU) in this section.

Remove the 4 ABS module-to-HCU screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).

To install, reverse the removal procedure.
- For vehicles equipped with AdvanceTrac®, carry out the IVD Initialization sequence. Follow the scan tool directions.

Anti-Lock Control

Anti-Lock Braking The ABS consists of the following components: ABS module — attached to the Hydraulic Control Unit (HCU) , but can be serviced separately from the HCU . Front wheel spe ...

More about Ford Focus:

Ford Focus Safety Belt Maintenance
Inspection WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to fol ...