Ford Focus Service Manual: Brake Disc
Item |
Part Number |
Description |
1 |
W700672 |
Brake caliper anchor plate bolts (2 required) |
2 |
— |
Brake caliper and anchor plate assembly |
3 |
700936 |
Brake flexible hose retaining clip |
4 |
1125 |
Brake disc |
Removal and Installation
- Remove the wheel and tire. For additional information, refer to Section
204-04.
- Remove the brake hose retaining clip and hose from the support bracket.
- NOTICE: Do not allow the caliper to hang by the brake hose or damage
to the hose can occur.
Remove the 2 brake caliper anchor plate bolts.
- Support the brake caliper and anchor plate assembly using mechanic's
wire.
- To install, tighten new bolts to 125 Nm (92 lb-ft).
- Remove the brake disc.
- To install, reverse the removal procedure.
- Apply brakes several times to verify correct brake operation.
Removal and Installation
Item
Part Number
Description
1
W700672
Brake caliper anchor plate bolts (2 required)
2
2B292
Brake caliper anchor p ...
NOTE: Do not use a bench lathe to machine the brake discs. Use an on-vehicle
brake lathe only. Read the entire operating manual and/or view the video shipped
with the lathe before installing, oper ...
More about Ford Focus:
Ford Focus General information
CAUTIONS:
Use only approved wheel and tyre
sizes. Using other sizes could
damage the vehicle and will make
the National Type Approval invalid.
If you change the diameter of the
tyres from that fitted at the factory,
the speedometer may not display
the correct speed. Take the vehicle to
...