Ford Focus Service Manual: Fog Lamp Bulb - Removal and Installation
NOTE:
Sedan shown, coupe similar.
| Item | Part Number | Description |
|---|---|---|
| 1 | — | Fog lamp electrical connector (part of 14290) |
| 2 | 13N021 | Fog lamp bulb |
Removal and Installation
WARNING: The bulb
contains gas under pressure. The bulb may shatter if the glass envelope is scratched
or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the
glass envelope. Failure to follow these instructions may result in personal injury.
NOTE:
The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on the fog lamps with the bulb removed.
NOTE:
Make sure that the headlamp switch and the ignition switch are in the OFF position.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
- NOTE:
Rotate the fog lamp counterclockwise approximately one-eighth turn to remove.
Disconnect the electrical connector and remove the fog lamp bulb.
- To install, reverse the removal procedure.
Bulbs
...
Headlamp Bulb - Removal and Installation
NOTE: The headlamp assembly is shown removed for clarity.
Item
Part Number
Description
1
13008
Headlamp assembly
2
13N021
Headlamp bulb
...
More about Ford Focus:
Ford Focus Piston Selection - Engine System
NOTE: The cylinder bore must be within the specifications for taper
and out-of-round before fitting a piston.
Select a piston size based on the cylinder bore.
NOTE: For precision fit, new pistons are divided into 3 categories
within each size range based on their relative pos ...
