Ford Focus manuals

Ford Focus Service Manual: Battery, Mounting and Cables

Ford Focus Service Manual / Electrical / Battery System / Battery, Mounting and Cables

Removal and Installation

WARNING: Batteries
contain sulfuric acid and produce explosive gases. Work in a well-ventilated area. Do not allow the battery to come in contact with flames, sparks or burning substances. Avoid contact with skin, eyes or clothing. Shield eyes when working near the battery to protect against possible splashing of acid solution. In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15 minutes, then get prompt medical attention. If acid is swallowed, call a physician immediately. Failure to follow these instructions may result in serious personal injury.

WARNING: Always
lift a plastic-cased battery with a battery carrier or with hands on opposite corners. Excessive pressure on the battery end walls may cause acid to flow through the vent caps, resulting in personal injury and/or damage to the vehicle or battery.

  1. Disconnect the battery. For additional information, refer to Battery Disconnect in this section.
  1. Open the wire harness clamp and remove the harness from the clamp.
  1. Thread the wire harness retainer off of the battery hold-down stud.
  1. Remove the 2 nuts from the battery clamp and remove the clamp.
    • To install, tighten to 3 Nm (27 lb-in).
  1. Remove the battery.
  1. To install, reverse the removal procedure.
    • Install and close the positive battery terminal cover.
Battery Disconnect
WARNING: Batteries contain sulfuric acid and produce explosive gases. Work in a well-ventilated area. Do not allow the battery to come in contact with flames, sparks or burning substances. Avoid ...

Battery, Mounting and Cables Inspection And Verification
Verify the customer concern. Visually inspect for obvious signs of mechanical or electrical damage.   Visual Inspection Chart Mechanical E ...

More about Ford Focus:

Ford Focus Front Impact Severity Sensor
  Item Part Number Description 1 W712191 Front impact severity sensor bolt 2 14B006 Front impact severity sensor 3 — Front impact severity sensor electrical connector (part of 14290) Removal and Installation WAR ...

© 2016-2024 Copyright www.ffguide.net