For optimum calibration, drive to an open, level location away from large metallic objects or structures such as bridges, steel buildings, etc. Switch off all non-essential electrical accessories (heated rear window, heater fan, A/C, map lamps, and wipers) and make sure all doors are closed.
Start the vehicle.
The vehicle remains in CAL mode until the compass has been successfully calibrated.
NOTE:
While pressing and holding the Front Controls Interface Module (FCIM) preset buttons 7 and 9, the compass display first enters the ZONE setting mode (after 5 seconds) and then after another 5 seconds (10 seconds total), the compass display enters the CAL mode.
Press and hold the FCIM preset buttons 7 and 9 for approximately 10 seconds until the CAL indicator appears in the compass display, then release the buttons.If the CAL indicator does not turn off after the vehicle is driven in a circle at least 5 times, repeat the procedure.
Drive the vehicle slowly at less than 5 km/h (3 mph) in a continuous circle until the C or CAL indicator disappears from the display and the compass heading is displayed.
Ford Focus Output Shaft Speed (OSS) Sensor
Material
Item
Specification
Motorcraft® MERCON® LV Automatic Transmission Fluid
XT-10-QLVC (US); CXT-10-LV12 (Canada)
MERCON® LV
Output Shaft Speed (OSS) Sensor
Item
Part Number
Description
1
W500214-S439
Bolt
...