Ford Focus Service Manual: Connecting Rod to Crankshaft Side Clearance
Special Tool(s)
|
Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent |
NOTE:
Refer to the appropriate Section 303-01 for the specification.
- Using the Feeler Gauge Set, measure the clearance between the connecting
rod and the crankshaft. Verify the measurement is within specification.
NOTE: Refer to the appropriate Section 303-01 for the specification.
Subtract the piston diameter from the cylinder bore diameter to find the
piston-to-cylinder bore clearance.
...
Special Tool(s)
Dial Indicator Gauge with Holding Fixture
100-002 (TOOL-4201-C) or equivalent
NOTE: Refer to the appropriate Section 303-01 for the specification.
...
More about Ford Focus:
Ford Focus Disarming the engine immobiliser
The engine immobiliser is disarmed
automatically when you switch the ignition
on with a correctly coded key.
The indicator in the instrument cluster will
come on for approximately three seconds
and then go out. If the indicator stays on
for one minute or flashes for
approximately one minute a ...