Ford Focus Service Manual: Coolant Pump
Material
| Item | Specification |
|---|---|
| Motorcraft® Premium Gold Engine Coolant VC-7-B (US); CVC-7-B (Canada) | WSS-M97B51-A1 |
Coolant Expansion Tank
| Item | Part Number | Description |
|---|---|---|
| 1 | W701107 | Coolant expansion tank bolt (2 required) |
| 2 | 8C045 | Coolant expansion tank |
Coolant Pump
| Item | Part Number | Description |
|---|---|---|
| 3 | W500221 | Coolant pump pulley bolt (3 required) |
| 4 | 8509 | Coolant pump pulley |
| 5 | W500015 | Coolant pump bolt (3 required) |
| 6 | 8501 | Coolant pump |
| 7 | 8507 | Coolant pump O-ring seal |
Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
- Remove the 2 bolts and position aside the coolant expansion tank.
- To install, tighten to 4 Nm (35 lb-in).
- Loosen the 3 coolant pump pulley bolts.
- Remove the accessory drive belt. For additional information, refer to Section 303-05.
- Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
- Remove the 3 coolant pump pulley bolts and the pulley.
- To install, tighten to 20 Nm (177 lb-in).
- NOTICE: Make sure the coolant pump is correctly seated to the engine
block before installing and tightening the fasteners, or damage to the coolant
pump may occur.
Remove the 3 coolant pump bolts and the coolant pump.
- To install, tighten to 10 Nm (89 lb-in).
- NOTE:
Install a new coolant pump O-ring seal and lubricate with clean engine coolant.
To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
Engine Cooling - Description and Operation
NOTICE: The engine cooling system is filled with Motorcraft® Premium Gold
Engine Coolant. Do not mix coolant types. Mixing coolant types degrades the corrosion
protection of Motorcraft® Premium ...
Coolant Expansion Tank
Item
Part Number
Description
1
8N029
Overflow hose
2
W701107
Coolant expansion tank bolt (2 required)
3
8C045
Coolant expansi ...
More about Ford Focus:
Ford Focus All engines Assembly
NOTE: If the oil squirters are being reused, they must be installed
in the same location as marked during disassembly.
NOTE: The front bulkhead does not have an oil squirter.
Install the 4 oil squirters.
Tighten to 4 Nm (35 lb-in).
Measure each of the cranksh ...
© 2016-2024 Copyright www.ffguide.net
