Ford Focus Service Manual: Cylinder Bore Taper
NOTE:
Refer to the appropriate Section 303-01 for the specification.
- Measure the cylinder bore at the top, middle and bottom of piston ring travel
in 2 directions as indicated. Verify the cylinder bore is within the wear limit.
The difference indicates the cylinder bore taper. If the cylinder bore taper
does not meet specification, bore the cylinder to the next oversize limit.
NOTE: Refer to the appropriate Section 303-01 for the specification.
Measure the cylinder bore in 2 directions. The difference is the out-of-round.
...
NOTE: Refer to the appropriate Section 303-01 for the specification.
Subtract the piston diameter from the cylinder bore diameter to find the
piston-to-cylinder bore clearance.
...
More about Ford Focus:
Ford Focus Fender
Removal
Remove the front bumper cover. For additional information, refer to Section
501-19.
Remove the headlamp assembly. For additional information, refer to Section
417-01.
Remove the fender splash shield. For additional information, refer to Fender
Splash S ...