Ford Focus Service Manual: Door Lock Cylinder
Removal and Installation
- Remove the front door exterior handle reinforcement. For additional information,
refer to Door Handle Reinforcement — Exterior, Front in this section.
- Release the clip and slide the door lock cylinder out of the exterior front
door handle reinforcement.
- NOTE:
Make sure to align the D-slot on the door lock cylinder
with the D-slot on the door lock cylinder lever.
To install, reverse the removal procedure.
NOTE: An incorrectly adjusted exterior door handle can cause a loose
handle, rattle noise, door hard to open from the outside door handle, or the outside
door handle to not sit flush in the closed ...
Item
Part Number
Description
1
—
Air inlet mode door actuator electrical connector (part of 18B604)
2
—
Air inlet mode door actuator sc ...
More about Ford Focus:
Ford Focus Brake and clutch fluid check
WARNINGS:
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse
the affected areas immediately with
plenty of water and contact your doctor.
If the level is at the MIN mark, have
the system checked by a properly
trained technician as soon as
possible.
Note: The brake ...