Ford Focus Service Manual: Engine Mount

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Engine Mount

Special Tool(s)

Engine Support Bar 303-F072

Coolant Expansion Tank

Item	Part Number	Description
1	W701107	Coolant expansion tank bolt (2 required)
2	8C045	Coolant expansion tank

Engine Mount

Item	Part Number	Description
1	W520214	Engine mount nut (2 required)
2	W710332	Engine mount bolt (2 required)
3	W712325	Engine mount stud bolt
4	6F012	Engine mount

Removal and Installation

Remove the 2 expansion tank bolts.
- To install, tighten to 4 Nm (35 lb-in).

Lift the coolant expansion tank off of the engine mount stud bolt and position it aside.

Install the Engine Support Bar.

Remove the 2 engine mount nuts.
- To install, tighten to 90 Nm (66 lb-ft).

Remove the 2 bolts, stud bolt and the engine mount.
- To install, tighten to 48 Nm (35 lb-ft).

To install, reverse the removal procedure.

Cylinder Head Temperature (CHT) Sensor

Item Part Number Description 1 9H589 Cylinder Head Temperature (CHT) sensor electrical connector 2 12A674 CHT sensor Removal and Inst ...

Seals and Gaskets

...

More about Ford Focus:

Ford Focus Diagnostic Parameters Identification (PID) Chart
Using Output State Control and Accessing PIDs To confirm that the output state control value was sent by the scan tool and the PCM has accepted the output state control substitution, a corresponding PID or PIDs for each output state control parameter should be monitored. Additional PIDs shou ...