Ford Focus Service Manual: Exhaust Manifold Cleaning and Inspection
|
Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent |
- Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces.
- NOTE:
New exhaust manifold gaskets, studs, nuts and/or bolts must be installed when an exhaust manifold is serviced.
NOTE:
Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.
Using the Straightedge and a Feeler Gauge Set, check the exhaust manifold sealing surface for warpage. If the warpage is greater than 0.76 mm (0.0299 in), install a new exhaust manifold.
Muffler and Tailpipe
Removal
NOTE: The production muffler and tailpipe assembly is one-piece construction.
The service muffler and tailpipe is 3-piece construction for Partial Zero Emissions
Vehicle (PZEV) and 2-pie ...
Exhaust Flexible Pipe
NOTE: This procedure is for all Partial Zero Emissions Vehicle (PZEV)
. The non-PZEV exhaust flexible pipe is part of the catalytic converter. For additional
information, refer to Catalytic Conver ...
More about Ford Focus:
Ford Focus Ignition switch
WARNING:
Never return the key to position 0
or I when the vehicle is in motion.
0 The ignition is off.
I The ignition and all main electrical circuits
are disabled.
Note: Do not leave the ignition key in this
position for too long to avoid discharging
the battery.
II The ignition is s ...
