Ford Focus Service Manual: Heated Oxygen Sensor (HO2S)

Ford Focus Service Manual / Powertrain / Internal Combustion Powertrain Control / Engine Control / Heated Oxygen Sensor (HO2S)

Special Tool(s)

Socket, Exhaust Gas Oxygen Sensor 303-476 (T94P-9472-A)

Material

Item	Specification
High Temperature Nickel Anti-Seize Lubricant XL-2	ESE-M12A4-A
Penetrating and Lock Lubricant (US); Penetrating Fluid (Canada) XL-1 (US); CXC-51-A (Canada)	—

Removal and Installation

Disconnect the electrical connector and detach the wiring retainer.

NOTE:
If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.
Using the Exhaust Gas Oxygen Sensor Socket, remove the Heated Oxygen Sensor (HO2S) .
- Calculate the correct torque wrench setting for the following torque. Refer to the Torque Wrench Adapter Formulas in the Appendix.
- To install, tighten to 48 Nm (35 lb-ft).

NOTICE: Make sure that the sensor wiring is routed away from hot surfaces and sharp edges or damage to the wiring may occur.

NOTE:
Apply a light coat of anti-seize lubricant to the threads of the HO2S .

NOTE:
Make sure that the electrical connector locking tab is engaged.
To install, reverse the removal procedure.

Catalyst Monitor Sensor

Special Tool(s) Socket, Exhaust Gas Oxygen Sensor 303-476 (T94P-9472-A) Material Item Specification High Temperature Nickel Anti-Seize Lubrica ...

Mass Air Flow (MAF) Sensor

Item Part Number Description 1 14A464 Mass Air Flow (MAF) sensor electrical connector 2 W709287 MAF sensor screw (2 required) 3 ...

More about Ford Focus:

Ford Focus Principle of operation
CAUTION: Using the system with the engine off will drain the battery. Voice recognition enables operation of the system without the need to divert your attention from the road ahead in order to change settings, or receive feedback from the system. Whenever you issue one of the defined c ...