Ford Focus Service Manual: Instrument Panel Finish Panel - RH

Ford Focus Service Manual / Body / Body Interior / Dashboard Assembly / Instrument Panel Finish Panel - RH

Removal and Installation

Lower the glove compartment door.
- Open the glove compartment door.
- Depress the 2 glove compartment stops and fully lower the glove compartment door.

NOTE:
The RH instrument panel finish panel is removed for clarity.
If equipped, disconnect the Accessory Protocol Interface Module (APIM) electrical connectors through the glove compartment door opening.

Remove the RH instrument panel finish panel screw located on the back of the RH instrument panel finish panel through the glove compartment door opening.

Remove the RH instrument panel finish panel.
- Pull the RH instrument panel finish panel outward to release the RH instrument panel finish panel retaining clips.
- Remove the RH instrument panel finish panel tether screw.

To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the adjacent retaining clip holes.

Instrument Panel Finish Panel - Center

Removal and Installation All vehicles NOTE: The instrument panel center finish panel should be replaced when the Audio Control Module (ACM) or the HVAC module has been removed from the instrumen ...

Instrument Cluster Finish Panel

Removal and Installation Lower the steering wheel. Remove the upper steering column shroud. Lift the upper steering column shroud upward to release the upper steering column shro ...

More about Ford Focus:

Ford Focus Ignition switch
WARNING: Never return the key to position 0 or I when the vehicle is in motion. 0 The ignition is off. I The ignition and all main electrical circuits are disabled. Note: Do not leave the ignition key in this position for too long to avoid discharging the battery. II The ignition is s ...