Ford Focus Service Manual: Intermediate Shaft Bearing
Special Tool(s)
|
Puller, Bearing
205-D064 (D84L-1123-A) |
Removal
- Remove the intermediate shaft. For additional information, refer to Intermediate
Shaft in this section.
- Using the Bearing Puller, press the intermediate shaft bearing off the intermediate
shaft.
- NOTE:
Rotate the Bearing Puller so the flat side is facing upward.
Make sure the inner bearing race is supported while pressing the bearing on.
Using the Bearing Puller, press the new intermediate shaft bearing onto the
intermediate shaft.
- Install the intermediate shaft. For additional information, refer to Intermediate
Shaft in this section.
Special Tool(s)
Installer, Constant Velocity Joint Boot Clamp
205-343 (T95P-3514-A)
Material
Item
Specification
Constant Velocity Joint Grease ...
Special Tool(s)
Aligner, Crankshaft Sensor
303-1417
Installer, Camshaft Front Oil Seal
303-096 (T74P-6150-A)
Remover, Oil Seal ...
More about Ford Focus:
Ford Focus Principle of operation
Outside air
Keep the air intakes forward of the
windscreen free from obstruction (snow,
leaves etc.) to allow the climate control
system to function effectively.
Recirculated air
CAUTION:
Prolonged use of recirculated air may
cause the windows to mist up. If the
windows mist up, follow th ...