Ford Focus Service Manual: Multifunction Display

Ford Focus Service Manual / Accessories / Multifunction Display

Item	Part Number	Description
1	7804302	Instrument panel upper finish panel
2	W710147-S	Front Display Interface Module (FDIM) screws (3 required)
3	—	FDIM electrical connector (part of 14401)
4	14D008	FDIM

Removal and Installation

NOTE:
Module configuration is only required if a new Front Display Interface Module (FDIM) is being installed.
Upload the FDIM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Section 418-01.

Remove the instrument panel upper finish panel by pulling straight up.

Remove the 3 FDIM screws.

Remove the FDIM .
- Disconnect the electrical connector.

To install, reverse the removal procedure.
- Download the configuration information to the FDIM . For additional information, refer to PMI in Section 418-01.

Universal Transmitter Programming - General Procedures

Universal Transmitter Programming (Fixed Code) — Early Build (Homelink®) NOTE: A new battery in the hand-held transmitter may allow quicker and easier training due to a more accurate transmiss ...

Security & Keyless Entry

...

More about Ford Focus:

Ford Focus Scuff Plate Trim Panel
Removal and Installation Remove the scuff plate trim panel. Pull the scuff plate trim panel upwards to release the retaining clips. For additional information on the retaining clip location, refer to Interior Trim — Exploded View in this section. NOTICE: To avoid da ...