Ford Focus manuals

Ford Focus Service Manual: Stability Control Sensor Cluster

Ford Focus Service Manual / Chassis / Brake Control and Vehicle Dynamics / Dynamics Control / Stability Control Sensor Cluster

Special Tool(s)

 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool


 
Item Part Number Description
1 2C011 Stability control sensor cluster electrical connector
2 W500011 Stability control sensor cluster bracket bolt (3 required)
3 W707142 Stability control sensor cluster nut (2 required)
4 3C187 Stability control sensor cluster
5 2C304 Stability control sensor cluster bracket

Removal and Installation

  1. Remove the RH front seat. For additional information, refer to Seat — Front in Section  501-10.
  1. Remove the pin-type retainer and position the RH rear footwell duct aside.

  1. Remove the 3 stability control sensor cluster bolts and position the sensor cluster to access the electrical connector.
    • To install, tighten to 10 Nm (89 lb-in).
  1. Disconnect the electrical connector and remove the sensor cluster assembly.
  1. Remove the 2 stability control sensor cluster nuts and the stability control sensor cluster.
    • To install, tighten to 8 Nm (71 lb-in).
  1. To install, reverse the removal procedure.
    • Carry out the IVD Initialization sequence. Follow the scan tool directions.
Hydraulic Control Unit (HCU)
Special Tool(s) Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool Material ...

Sensors
...

More about Ford Focus:

Ford Focus Coolant Pump
Material Item Specification Motorcraft® Premium Gold Engine Coolant VC-7-B (US); CVC-7-B (Canada) WSS-M97B51-A1 Coolant Expansion Tank   Item Part Number Description 1 W701107 Coolant expansion tank bolt (2 required) ...

© 2016-2024 Copyright www.ffguide.net