Ford Focus Service Manual: Window Glass - Front Door
Material
Item |
Specification |
Seam Sealer
TA-2 |
— |
Removal and Installation
- Remove the front door speaker. For additional information, refer to Section
415-00.
- NOTE:
Do not touch the adhesive surface during removal or installation
of the watershield, as re-bonding will be impaired. If additional adhesive is
required during installation, apply seam sealer as necessary to completely seal
the watershield to the inner door.
Remove the watershield.
- Temporarily install the window control switch or the window regulator handle
to raise or lower the window to access the glass clamp bolts.
- Loosen the 2 door window glass clamp bolts.
- To install, tighten to 8 Nm (71 lb-in).
- Tape the window in position, then lower the window regulator downward until
it reaches the stops at the bottom of the regulator tracks.
- Remove the window glass.
- Lift the glass.
- Tip the glass forward and remove the glass from the front of the door.
- To install, reverse the removal procedure.
NOTE: RH shown, LH similar.
Item
Part Number
Description
1
W712191
Side impact sensor bolts
2
—
Side impact sensor electrical connector (p ...
Material
Item
Specification
Seam Sealer
TA-2
—
Removal and Installation
Remove the rear door speaker. For additional information, refer to Section
...
More about Ford Focus:
Ford Focus Tyre care
Tyre care
To make sure the front and rear tyres of
your vehicle wear evenly and last longer,
we recommend that you swap the tyres
from front to rear and vice versa at regular
intervals of between 5 000 and 10 000
km (3 000 and 6 000 miles).
CAUTION:
Do not scrub the sidewalls of the
t ...