Ford Focus Service Manual: Window Regulator Motor - Rear Door
Material
Item |
Specification |
Seam Sealer
TA-2 |
— |
Removal and Installation
- Remove the rear door speaker. For additional information, refer to Section
415-00.
- NOTE:
Do not touch the adhesive surface during removal or installation
of the watershield, as re-bonding will be impaired. If additional adhesive is
required during installation, apply seam sealer as necessary to completely seal
the watershield to the inner door.
Remove the watershield.
- Temporarily install the window control switch or the window regulator handle
to raise or lower the window to align the regulator clamp with the access hole.
- Push out the pin and then push out the sleeve of the 2-part spacer.
- Tape the window glass in position, then lower the window regulator downward
until it reaches the stops at the bottom of the regulator tracks.
- Disconnect the window regulator motor electrical connector.
- Remove the 3 window regulator bolts.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the 3 window regulator motor screws and the window regulator motor
assembly.
- Position the window regulator and motor assembly as necessary within
the door to access the window regulator motor screws.
- To install, tighten to 4 Nm (35 lb-in).
- To install, reverse the removal procedure.
Material
Item
Specification
Seam Sealer
TA-2
—
Removal and Installation
Remove the front door speaker. For additional information, refer to Section
...
Material
Item
Specification
Seam Sealer
TA-2
—
Removal and Installation
Remove the front door speaker. For additional information, refer to Section
...
More about Ford Focus:
Ford Focus Steering Column - Description and Operation
The steering column consists of the following:
Steering wheel
Steering column
Upper and lower steering column shafts
Steering column switches
The steering column is the mechanical linkage between the steering wheel and
the steering gear. The steering wheel is mounted to a shaft, ...