Ford Focus Service Manual: Connecting Rod Bend

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Connecting Rod Bend

Special Tool(s)

Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Using the Feeler Gauge Set, measure the connecting rod bend on a suitable alignment fixture. Follow the instructions of the fixture manufacturer. Verify the bend measurement is within specification.

Crankshaft Main Bearing Journal-to-Bearing Clearance

NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Crankshaft main bearing journals must be within specifications before checking journal clearance. Remove the cranks ...

Connecting Rod Bushing Diameter

NOTE: Refer to the appropriate Section 303-01 for the specification. Use a telescoping gauge to determine the ID of the connecting rod bushing, if equipped. Measure the telescop ...

More about Ford Focus:

Ford Focus Roof Opening Panel - Removal and Installation
Removal NOTE: Make sure the roof opening panel is in the CLOSED position. Remove the headliner. For additional information, refer to Section 501-05. Disconnect the 2 front and the 2 rear drain hoses from the roof opening panel. Disconnect the roof opening panel ...