Ford Focus Service Manual: Cylinder Block Distortion

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Cylinder Block Distortion

Special Tool(s)

Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent

NOTE:

Refer to the appropriate Section 303-01 for the specification.

NOTE:
Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.
Use a Straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.

Cylinder Bore Cleaning

Material Item Specification Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil (US); Motorcraft® SAE 5W-20 Super Premium Motor Oil (Canada) XO-5W20-QSP (US); CXO- ...

More about Ford Focus:

Ford Focus Front Door Latch
Removal NOTE: The door window glass must be completely raised. Remove the front door trim panel. For additional information, refer to Section 501-05. Position the watershield aside. Disconnect the front door latch actuator electrical connector. Open the clip and ...