Ford Focus manuals

Ford Focus Service Manual: Fuel Level Sender


 
Item Part Number Description
1 Fuel level sender electrical connector (part of 9A299)
2 9A299 Fuel level sender
3 9H307 Fuel Pump (FP) module

Removal and Installation

WARNING: Do not
smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

WARNING: Do not
carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

WARNING: When handling
fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.

WARNING: Always
disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

  1. Remove the Fuel Pump (FP) module. For additional information, refer to Fuel Pump Module in this section.
  1. Disconnect the fuel level sender electrical connector.
  1. Depress the lock tabs and slide the fuel level sender upwards.
    • Remove the sender from the FP module.

  1. To install, reverse the removal procedure.
Inertia Fuel Shutoff (IFS) Switch
  Item Part Number Description 1 W710254 Pin-type retainer (2 required) 2 5402344 RH A-pillar lower trim panel 3 W504169 Inerti ...

Fuel Tank Draining
Special Tool(s) Fuel Storage Tanker 164-R3202 or equivalent WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near ...

More about Ford Focus:

Ford Focus Connecting Rod Cleaning
NOTICE: Do not use a caustic cleaning solution or damage to connecting rods can occur. NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the original connecting rod in the original position. Do not reverse the cap. Parts are not interchange ...

© 2016-2024 Copyright www.ffguide.net