Ford Focus Service Manual: Ignition Lock Cylinder - Removal and Installation

Ford Focus Service Manual / Accessories / Security & Keyless Entry / Ignition/Push Start and Steering Lock / Ignition Lock Cylinder - Removal and Installation

Item	Part Number	Description
1	3F642	Steering column lock module
2	11582	Ignition lock cylinder

Removal and Installation

NOTE:

For non-functional ignition lock cylinders, the steering column lock module has to be replaced. For additional information, refer to Section 211-05.

Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to Section 419-01B.

Remove the ignition lock cylinder.
1. Insert and turn the ignition key to the ACC position.
1. Using a suitable tool, press the detent.
1. Remove the lock cylinder.

If a new lock cylinder with keys is replaced, the new PATS keys must be programmed. For additional information, refer to Key Programming Using Diagnostic Equipment in Section 419-01B.

To install, reverse the removal procedure.

Ignition/Push Start and Steering Lock

...

Ignition Switch - Removal and Installation

Item Part Number Description 1 3530 Upper steering column shroud 2 W713494 Lower steering column shroud screw (3 required) 3 353 ...

More about Ford Focus:

Ford Focus Piston Ring-to-Groove Clearance
Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Inspect the piston for ring land damage or accelerated wear. Using the Feeler Gauge Set, measure the piston ...