Ford Focus manuals

Ford Focus Service Manual: Instrument Panel Finish Panel - RH

Ford Focus Service Manual / Body / Body Interior / Dashboard Assembly / Instrument Panel Finish Panel - RH

Removal and Installation

  1. Lower the glove compartment door.
    • Open the glove compartment door.
    • Depress the 2 glove compartment stops and fully lower the glove compartment door.

  1. NOTE:

    The RH instrument panel finish panel is removed for clarity.

    If equipped, disconnect the Accessory Protocol Interface Module (APIM) electrical connectors through the glove compartment door opening.


  1. Remove the RH instrument panel finish panel screw located on the back of the RH instrument panel finish panel through the glove compartment door opening.
  1. Remove the RH instrument panel finish panel.
    • Pull the RH instrument panel finish panel outward to release the RH instrument panel finish panel retaining clips.
    • Remove the RH instrument panel finish panel tether screw.
  1. To install, reverse the removal procedure.
    • Make sure to align the trim panel retaining clips to the adjacent retaining clip holes.
Instrument Panel Finish Panel - Center
Removal and Installation All vehicles NOTE: The instrument panel center finish panel should be replaced when the Audio Control Module (ACM) or the HVAC module has been removed from the instrumen ...

Instrument Cluster Finish Panel
Removal and Installation Lower the steering wheel. Remove the upper steering column shroud. Lift the upper steering column shroud upward to release the upper steering column shro ...

More about Ford Focus:

Ford Focus Remote Keyless Entry (RKE) Transmitter Programming - General Procedures
NOTE: A maximum of 4 Remote Keyless Entry (RKE) transmitters can be programmed to the vehicle. Programming must be done at the same time for all the RKE transmitters. NOTE: Programming (or reprogramming) of the RKE transmitters can be accomplished using a scan tool or by carrying out the fol ...

© 2016-2025 Copyright www.ffguide.net