Ford Focus Service Manual: Toe Adjustment - Front
- Using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
- Using alignment equipment and the manufacturer's instructions, measure the toe.
- Loosen the tie-rod end jam nuts.
- Remove the steering gear boot outer clamps.
- Rotate the tie rods as necessary to adjust the toe setting.
- Tighten the tie-rod end jam nuts to 80 Nm (59 lb-ft).
- Install the steering gear boot outer clamps.
- Recheck the toe settings, adjust as necessary.
Ride Height Measurement
Front Ride Height Measurement
Item
Description
1
Ride height = 2 - 3
2
Measurement 2
3
Measurement 3
NOTE: M ...
Toe Adjustment - Rear
Jounce the vehicle to make sure that the suspension is in its normal resting
position.
Using alignment equipment and the manufacturer's instructions, measure the
toe.
With t ...
More about Ford Focus:
Ford Focus Cylinder Bore Taper
NOTE: Refer to the appropriate Section 303-01 for the specification.
Measure the cylinder bore at the top, middle and bottom of piston ring travel
in 2 directions as indicated. Verify the cylinder bore is within the wear limit.
The difference indicates the cylinder bore taper. If the cyl ...
© 2016-2026 Copyright www.ffguide.net
