Ford Focus Owners Manual: Trip computer
Type 2 and 3
Odometer
Registers the total mileage of the vehicle.
Tripmeter
Registers the mileage of individual journeys.
Distance to empty
Indicates the approximate distance the vehicle will travel on the fuel remaining in the tank. Changes in driving pattern may cause the value to vary.
Instantaneous fuel consumption
Indicates the current average fuel consumption.
Average fuel consumption
Indicates the average fuel consumption since the function was last reset.
Average speed
Indicates the average speed calculated since the function was last reset.
Outside air temperature
Shows the outside air temperature.
Hold 'SET' to set Tyre Pres.
Recalibrates the system to the actual pressure of the tyres. See Tyre pressure monitoring system.
Menu
Enters the main menu. See General information.
Trip computer A
Odometer B
Tripmeter C
The trip computer includes the following information displays:
Turn the rotary control to scroll through the trip computer displays.
Note: The position of the trip computer display may vary depending on the information shown in the display.
Resetting the trip computer using the main menu
To reset a particular display:
1. Turn the rotary control and highlight Menu.
2. Press the SET/RESET button.
3. Highlight "Reset Trip".
4. Press the SET/RESET button.
5. Highlight the function to be reset.
6. Press and hold the SET/RESET button.
General information
WARNING:
Do not operate the information
display controls when the vehicle is
moving.
Note: The information display will remain
on for several minutes after you switch off
the ignition.
Variou ...
Personalised settings
1. Use the rotary to enter the main
menu.
2. Press the SET/RESET button to
choose a sub-menu and adjust the
settings.
ESP
Select this option to activate or deactivate
ESP.
1. Use the rotary ...
More about Ford Focus:
Ford Focus Servo Bore Repair
NOTE: The 4F27 Servo Bore Master Repair Kit NRL4F27 should be used
to repair a transmission case with 2-4 band servo pin bore wear. The use of this
kit will repair the 2-4 band servo pin bore back to OEM specifications.
Install the drill jig and the 6mm bolts.
Secure the 7/16â ...
