Ford Focus Service Manual: Accessory Drive Belt Tensioner

Ford Focus Service Manual / Powertrain / Engine / Pulleys and Belts / Accessory Drive Belt Tensioner

Removal and Installation

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

Remove the 2 bolts and accessory drive belt splash shield.
- To install, tighten to 9 Nm (80 lb-in).

Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the tensioner.

NOTE:
The accessory drive belt tensioner must be replaced as a complete unit.
Remove the 2 bolts and the accessory drive belt tensioner.
- To install, tighten to 25 Nm (18 lb-ft).

To install, reverse the removal procedure.

Crankshaft Pulley

Special Tool(s) Alignment Plate, Camshaft 303-465 (T94P-6256-CH) Holding Tool, Crankshaft Damper 303-1416 Timing Peg, Crankshaf ...

Accessory Drive Belt

Removal and Installation With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. Remove the 2 bolts and the accessory drive belt ...

More about Ford Focus:

Ford Focus Using the telephone - Vehicles Without: Navigation System
This chapter describes the phone functions of the audio unit. Note: Refer to your audio guide for details of the controls. An active phone must be present. Even if connected to the audio unit, your phone can still be used in the usual way. Note: You can exit the phone menu by pressing any ...