Ford Focus Service Manual: Brake Flexible Hose
| Item | Specification |
|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) | WSS-M6C62-A or WSS-M6C65-A1 |
| Item | Part Number | Description |
|---|---|---|
| 1 | W712276 | Brake caliper flow bolt |
| 2 | — | Brake tube fitting (part of 2C287) |
| 3 | W712362 | Copper washers |
| 4 | W700936 | Brake flexible hose retaining clip (2 required) |
| 5 | 2078 | Brake flexible hose |
Removal and Installation
WARNING: Do not
use any fluid other than clean brake fluid meeting manufacturer's specification.
Additionally, do not use brake fluid that has been previously drained. Following
these instructions will help prevent system contamination, brake component damage
and the risk of serious personal injury.
WARNING: Carefully
read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION
seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673.
For additional information, consult the product Material Safety Data Sheet (MSDS)
if available. Failure to follow these instructions may result in serious personal
injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
- Remove the brake caliper flow bolt and discard the 2 copper washers.
- To install, tighten to 48 Nm (35 lb-ft).
- Disconnect the brake tube fitting from the brake flexible hose.
- To install, tighten to 15 Nm (133 lb-in).
- Remove the 2 brake flexible hose retaining clips and the brake flexible hose.
- To install, reverse the removal procedure.
- Install new copper washers.
- Bleed the brake caliper. For additional information, refer to Section 206-00 for Component Bleeding.
Brake Fluid Reservoir
Material
Item
Specification
High Performance DOT 3 Motor Vehicle Brake Fluid
PM-1-C (US); CPM-1-C (Canada)
WSS-M6C62-A or WSS-M6C65-A1
Item
...
Brake Master Cylinder
Material
Item
Specification
High Performance DOT 3 Motor Vehicle Brake Fluid
PM-1-C (US); CPM-1-C (Canada)
WSS-M6C62-A or WSS-M6C65-A1
Item
...
More about Ford Focus:
Ford Focus Servo Bore Repair
NOTE: The 4F27 Servo Bore Master Repair Kit NRL4F27 should be used
to repair a transmission case with 2-4 band servo pin bore wear. The use of this
kit will repair the 2-4 band servo pin bore back to OEM specifications.
Install the drill jig and the 6mm bolts.
Secure the 7/16â ...
Nissan Frontier - Instrument Panel - Keys - Brake system
