Ford Focus Service Manual: Core Plug Replacement - Engine System
|
Slide Hammer 100-001 (T50T-100-A) |
| Item | Specification |
|---|---|
| Threadlock 262 TA-26 |
WSK-M2G351-A6 |
All core plugs
- NOTE:
Cylinder block core plug shown, cylinder head core plug similar.
Use the Slide Hammer and a freeze plug remover to remove the core plug.
- NOTE:
Oversize plugs are identified by the OS stamped in the flat located on the cup side of the plug.
Inspect the core plug bore for any damage that would interfere with the correct sealing of the plug. If the core plug bore is damaged, bore for the next oversize plug.
Cup-type
- NOTICE: Use care during this procedure so as not to disturb or distort
the cup sealing surface.
NOTE:
When installed, the flanged edge must be below the chamfered edge of the bore to effectively seal the bore.
Coat the cup-type core plug and bore lightly with sealant and install the core plug using a freeze plug installer.
Expansion-type
- NOTICE: Do not contact the crown when installing an expansion-type core
plug. This could expand the plug before seating and result in leakage.
Coat the expansion-type core plug and bore lightly with sealant and install the core plug using a freeze plug installer.
Bearing Inspection - Engine System
Inspect bearings for the following defects:
Cratering — fatigue failure
Spot polishing — incorrect seating
Imbedded dirty engine oil
Scratching — dirty eng ...
More about Ford Focus:
Ford Focus Engine coolant check
Checking the coolant level
WARNING:
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse
the affected areas immediately with
plenty of water and contact your doctor.
CAUTION:
Make sure that the level is between
the MIN and the MAX marks.
Note: Coolant expands when i ...
Nissan Frontier - Instrument Panel - Keys - Brake system
