Ford Focus Service Manual: Crankshaft End Play

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Crankshaft End Play

Special Tool(s)

Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Install the Dial Indicator Gauge with Holding Fixture.

Position the crankshaft to the rear of the cylinder block.

Zero the Dial Indicator Gauge.

Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.

Connecting Rod to Crankshaft Side Clearance

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Using the Feeler Gauge ...

Crankshaft Position (CKP) Sensor

Special Tool(s) Aligner, Crankshaft Sensor 303-1417 Timing Peg, Crankshaft TDC 303-507 General Equipment 6 mm x 18 mm bolt ...

More about Ford Focus:

Ford Focus Camber Adjustment - Rear
Using alignment equipment and the manufacturer's instructions, measure the rear camber. NOTE: If the rear camber is below the minimum specification, the camber can be adjusted +1.0 degree by replacing the upper arm with an upper arm repair kit (3S4Z-1A154-AA). Replace the u ...