Ford Focus Service Manual: Engine Oil Pressure (EOP) Switch - Engine - 2.0L - in Vehicle Repair

Ford Focus Service Manual / Powertrain / Engine / General Information / Engine Oil Pressure (EOP) Switch - Engine - 2.0L - in Vehicle Repair

Material

Item	Specification
Motorcraft® Thread Sealant with PTFE TA-24	WSK-M2G350-A2

Removal and Installation

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

Disconnect the Engine Oil Pressure (EOP) switch electrical connector.

Remove the EOP switch.
- To install, tighten to 15 Nm (133 lb-in).

NOTE:
Apply thread sealant to the EOP switch threads.
To install, reverse the removal procedure.

Engine - Manual Transaxle - Engine - 2.0L - Removal

Special Tool(s) 2,200# Floor Crane, Fold Away 300-OTC1819E or equivalent Lifting Bracket, Engine 303-050 (T70P-6000) Powertrain ...

Engine System - General Information

NOTICE: When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur. NOTE: Specificatio ...

More about Ford Focus:

Ford Focus Changing the remote control battery
Make sure that you dispose of old batteries in an environmentally friendly way. Seek advice from your local authority regarding recycling. Remote control with a folding key blade 1. Insert a screwdriver as far as possible into the slot on the side of the remote control, push it towar ...