Ford Focus Service Manual: Exhaust Flexible Pipe

Ford Focus Service Manual / Powertrain / Engine / Exhaust / Exhaust Flexible Pipe

NOTE:

This procedure is for all Partial Zero Emissions Vehicle (PZEV) . The non-PZEV exhaust flexible pipe is part of the catalytic converter. For additional information, refer to Catalytic Converter in this section.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

NOTICE: Do not excessively bend or twist the exhaust flexible pipe. Failure to follow these instructions may cause damage to the exhaust flexible pipe.

Support the exhaust flexible pipe with a support wrap or suitable splint.

Remove and discard the 2 exhaust flexible pipe-to-muffler and tailpipe assembly nuts.
- Discard the gasket.
- To install, tighten to 47 Nm (35 lb-ft).

Remove and discard the 2 exhaust flexible pipe-to-catalytic converter nuts and remove the exhaust flexible pipe.
- Discard the gasket.
- To install, tighten to 47 Nm (35 lb-ft).

To install, reverse the removal procedure.
- Install new gaskets and nuts.

Exhaust Manifold Cleaning and Inspection

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean t ...

Fuel System

...

More about Ford Focus:

Ford Focus Door Handle Reinforcement - Exterior, Rear
Removal NOTE: The door window glass must be completely raised. Remove the exterior rear door handle. For additional information, refer to Exterior Rear Door Handle in this section. Unclip the door lock rod bell crank from the door. Remove the interior rear door handle ...