Ford Focus Service Manual: Fender

Ford Focus Service Manual / Body / Body Exterior / Panels / Fender

Removal

Remove the front bumper cover. For additional information, refer to Section 501-19.

Remove the headlamp assembly. For additional information, refer to Section 417-01.

Remove the fender splash shield. For additional information, refer to Fender Splash Shield in this section.

Remove the bumper cover mounting bracket-to-radiator grille opening panel reinforcement pushpin.

Remove the bumper cover mounting bracket retainer nuts and remove the bracket.

Remove the front fender inner bolt.
- To install, tighten to 7 Nm (62 lb-in).

Remove the front fender lower bolt.
- To install, tighten to 7 Nm (62 lb-in).

Open the front door and remove the front fender rear bolt.
- To install, tighten to 7 Nm (62 lb-in).

Remove the front fender front bolt.

Remove the 2 front fender upper bolts and the fender.
- To install, tighten to 7 Nm (62 lb-in).

To install, reverse the removal procedure.

Inner Body Reinforcing Panels

General Equipment 3 Phase Inverter Spot Welder 254-00002 Compuspot 700F Welder 190-50080 I4 Inverter Spot Welder 254-00014 Inverter Welder with MIG Welder 254- ...

Fender Splash Shield

Removal and Installation With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. Remove the 10 fender splash shield pin-type reta ...

More about Ford Focus:

Ford Focus Electronic Compass
The compass signal originates from the compass module, which is integrated into the interior rear view mirror. The compass display is incorporated into the Front Display Interface Module (FDIM) . The buttons that allow the driver to operate the calibration and zone setting procedures are l ...