Ford Focus Service Manual: Front Fog Lamp Adjustment - General Procedures
Fog Lamp Adjustment Screw Location
- NOTE:
Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
Before starting the fog lamp assembly adjustment:
- check the tire inflation.
- make sure there are no other loads in the vehicle other than a half tank of fuel.
- make sure the vehicle is on level ground.
- make sure the fog lamps and headlamps are clean.
- make sure the headlamps are operating and are correctly aimed.
- NOTE:
The vertical wall screen must be a minimum of 2.4 m (8 ft) wide.
Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
- The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.
- If necessary, rotate the adjusting screw until the fog lamp beam is within specification.
Fog Lamp - Removal and Installation
Sedan
Item
Part Number
Description
1
15266
Fog lamp bezel
2
W706805
Fog lamp screws (4 required)
3
15200
Fog lamp
...
Headlamp Adjustment - General Procedures
Special Tool(s)
Vision 100 Photometric Headlamp Aimer
196-00005 or equivalent
Aiming Methods
NOTE: Refer to the Owners Literature for the headlamp adjustment screw
...
More about Ford Focus:
Ford Focus Changing a bulb
WARNINGS:
Switch the lights and the ignition off.
Let the bulb cool down before
removing it.
We recommend that you ask your
dealer to change the bulbs if your
vehicle is fitted with Xenon
headlamps. There is a risk of injury due to
high voltage.
CAUTIONS:
Do not touch the glass of ...
Nissan Frontier - Instrument Panel - Keys - Brake system
