Ford Focus Service Manual: Halfshaft Seal - RH (Manual Transaxle/Transmission — MTX75)

Ford Focus Service Manual / Powertrain / Driveline / Driveline Seals / Halfshaft Seal - RH (Manual Transaxle/Transmission — MTX75)

Special Tool(s)

	Installer, Halfshaft Oil Seal 308-039
	Remover, Halfshaft Oil Seal 307-163 (T86P-70043-A)
	Remover, Pilot Bearing 308-001 (T58L-101-B)

Material

Item	Specification
Motorcraft® Full Synthetic Manual Transmission Fluid XT-M5-QS	WSD-M2C200-C

Removal

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

Remove the RH halfshaft and intermediate shaft assembly. For additional information, refer to Section 205-04.

Using the Pilot Bearing Remover with the Halfshaft Oil Seal Remover, remove and discard the halfshaft oil seal.

Installation

Using the Halfshaft Oil Seal Installer, install the new halfshaft oil seal.

Install the RH halfshaft and intermediate shaft assembly. For additional information, refer to Section 205-04.

NOTE:
The fill height is 0.0-5.0 mm (0.0-0.2 in) below the lower edge of the filler hole.
Remove the transaxle fluid filler plug. Check the transaxle fluid level and fill with manual transmission fluid as necessary.
- Tighten to 35 Nm (26 lb-ft).

Halfshaft Seal - LH (Automatic Transaxle/Transmission — 4F27E)

Special Tool(s) Handle 205-153 (T80T-4000-W) Installer, Axle Oil Seal 205-259 (T87P-3254-A) Material Item Specification ...

Halfshaft Seal - RH (Automatic Transaxle/Transmission — 4F27E)

Special Tool(s) Handle 205-153 (T80T-4000-W) Installer, Output Shaft Seal 307-572 Material Item Specification Motorcr ...

More about Ford Focus:

Ford Focus Hydraulic Control Unit (HCU)
Special Tool(s) Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool Material Item Specification High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C ...

Nissan Frontier - Instrument Panel - Keys - Brake system