Ford Focus Service Manual: Horn - Removal and Installation

Ford Focus Service Manual / Body / Body Electrical / Horn / Horn - Removal and Installation

Item	Part Number	Description
1	—	Horn electrical connector (part of 14290)
2	—	Horn bracket bolt
3	13832	Horn

Removal and Installation

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

Disconnect the electrical connector.

Remove the horn bracket bolt and the horn.
- To install, tighten to 9 Nm (80 lb-in).

To install, reverse the removal procedure.

Horn - Description and Operation

NOTE: The Smart Junction Box (SJB) is also known as the Generic Electronic Module (GEM) . The horn system consists of the following components: Horn switch Horn relay (part of the SJB ) ...

Resetting The Keep Alive Memory (KAM) - Gasoline Engines (Powertrain Diagnostics)

Description Resetting the KAM returns the powertrain control module (PCM) memory to its default setting. Adaptive learning contents such as adaptive airflow, idle speed, refueling event, and fuel ...

More about Ford Focus:

Ford Focus Key Programming Using Two Programmed Keys - General Procedures
NOTE: This procedure only works if 2 or more programmed ignition keys are available. If 2 keys are not available, refer to Spare Key Programming — Using Diagnostic Equipment in this section. NOTE: The Instrument Cluster (IC) PID SPAREKEY must be enabled for this procedure to operate. If th ...