Ford Focus Service Manual: Intermediate Shaft Bearing
Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Intermediate Shaft Bearing
Special Tool(s)
|
Puller, Bearing 205-D064 (D84L-1123-A) |
Removal
- Remove the intermediate shaft. For additional information, refer to Intermediate Shaft in this section.
- Using the Bearing Puller, press the intermediate shaft bearing off the intermediate shaft.
- NOTE:
Rotate the Bearing Puller so the flat side is facing upward. Make sure the inner bearing race is supported while pressing the bearing on.
Using the Bearing Puller, press the new intermediate shaft bearing onto the intermediate shaft.
- Install the intermediate shaft. For additional information, refer to Intermediate Shaft in this section.
Intermediate Shaft
Special Tool(s)
Installer, Constant Velocity Joint Boot Clamp
205-343 (T95P-3514-A)
Material
Item
Specification
Constant Velocity Joint Grease ...
Engine Front Cover
Special Tool(s)
Aligner, Crankshaft Sensor
303-1417
Installer, Camshaft Front Oil Seal
303-096 (T74P-6150-A)
Remover, Oil Seal ...
More about Ford Focus:
Ford Focus Power Point
Special Tool(s)
Remover, Power Point Socket
501-039 or equivalent
Removal
NOTE: Power point cover may differ depending on location.
Open the power point cover.
Install the Power Point Socket Remover in one of the power point socket
slots.
...
Nissan Frontier - Instrument Panel - Keys - Brake system
© 2016-2026 Copyright www.ffguide.net
