Ford Focus Service Manual: Piston Pin Bore Diameter

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Piston Pin Bore Diameter

NOTE:

Refer to the appropriate Section 303-01 for the specification.

NOTE:
Piston and piston pins are a matched set and should not be interchanged.
Measure the piston pin bore diameter in 2 directions on each side. Verify the diameter is within specification.

Piston Ring-to-Groove Clearance

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Inspect the piston for ...

Piston Pin Diameter

NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the piston pin diameter in 2 directions at the points shown. Verify the diameter is within specification. ...

More about Ford Focus:

Ford Focus Camber Adjustment - Rear
Using alignment equipment and the manufacturer's instructions, measure the rear camber. NOTE: If the rear camber is below the minimum specification, the camber can be adjusted +1.0 degree by replacing the upper arm with an upper arm repair kit (3S4Z-1A154-AA). Replace the u ...