Ford Focus Service Manual: Temperature Blend Door Actuator

Ford Focus Service Manual / HVAC / Ventilation Doors / Temperature Blend Door Actuator

Item	Part Number	Description
1	—	Temperature blend door actuator electrical connector (part of 18B604)
2	—	Temperature blend door actuator screw (2 required)
3	19E616	Temperature blend door actuator (5-pin)

Removal and Installation

NOTE:

The temperature blend door actuator can be accessed from below the instrument panel to the right of the accelerator pedal.

Disconnect the temperature blend door actuator electrical connector.

Remove the 2 temperature blend door actuator screws.

Remove the temperature blend door actuator.

To install, reverse the removal procedure.

Air Distribution and Filtering

Air Distribution and Filtering NOTE: The air distribution system is not designed for use with a cabin air filter. A cabin air filter is not installed from the factory and is not available as a d ...

Mode Door Actuator - Air Inlet Door

Item Part Number Description 1 — Air inlet mode door actuator electrical connector (part of 18B604) 2 — Air inlet mode door actuator sc ...

More about Ford Focus:

Ford Focus Diagnostic Parameters Identification (PID) Chart
Using Output State Control and Accessing PIDs To confirm that the output state control value was sent by the scan tool and the PCM has accepted the output state control substitution, a corresponding PID or PIDs for each output state control parameter should be monitored. Additional PIDs shou ...