Ford Focus Service Manual: Thermostatic Expansion Valve
Material
| Item | Specification |
|---|---|
| Motorcraft® PAG Refrigerant Compressor Oil YN-12-D | WSH-M1C231-B |
| Item | Part Number | Description |
|---|---|---|
| 1 | W520413 | Thermostatic Expansion Valve (TXV) fitting nut |
| 2 | 19B596 | TXV fitting gasket seal kit (2 pieces from kit required) |
| 3 | — | TXV bolt (2 required) |
| 4 | 19849 | TXV |
| 5 | 19E889 | O-ring seal |
| 6 | 19E889 | O-ring seal |
Removal and Installation
- Remove the Thermostatic Expansion Valve (TXV) fitting nut and disconnect
the fitting.
- Discard the gasket seals.
- To install, tighten to 15 Nm (133 lb-in).
- Remove the 2 TXV bolts.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the TXV .
- Discard the O-ring seals.
- To install, reverse the removal procedure.
- Install new O-ring seals and gasket seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil. For additional information, refer to Section 412-00.
Heater Core And Evaporator Core Housing
Material
Item
Specification
Motorcraft® PAG Refrigerant Compressor Oil
YN-12-D
WSH-M1C231-B
Item
Part Number
Description
1
...
A/C Lines
...
More about Ford Focus:
Ford Focus Front Suspension Stabilizer Bar
Special Tool(s)
Remover, Tie-Rod End
211-001 (TOOL-3290-D)
Item
Part Number
Description
1
W710091
Subframe front bolt (4 required)
2
W709634
Subframe rear bolt (2 required)
3
5494
Stabilizer ...
© 2016-2026 Copyright www.ffguide.net
