Ford Focus manuals

Ford Focus Owners Manual: Tyre pressure monitoring system

Ford Focus Owners Manual / Wheels and tyres / Tyre pressure monitoring system

WARNINGS:

The system does not relieve you of your responsibility to regularly check the tyre pressures.

The system will only provide a low tyre pressure warning. It will not inflate the tyres.

Do not drive on significantly under-inflated tyres. This may cause the tyres to overheat and fail.

Under-inflation reduces fuel efficiency, tyre tread life and may also affect your ability to drive the vehicle safely.

CAUTIONS:

Do not bend or damage the valves when you are inflating the tyres.

Have tyres installed by properly trained technicians.

The Deflation Detection System will alert you if there is a change of air pressure in any tyre. It does this by using the ABS sensors to detect the rolling circumference of the wheels. When the circumference changes, this indicates low pressure in a tyre, a warning message is displayed in the information display and the message indicator will illuminate. See Information messages.

Apart from a too low tyre pressure or a damaged tyre, the following situations can affect the rolling circumference:

• Vehicle load is uneven.

• When using a trailer or travelling up and down an incline.

• Using snow chains.

• Driving on soft surfaces such as snow or mud.

Note: The system will still function correctly, but there may be an increased detection time.

If a low pressure warning message is displayed in the information display, check the tyre pressures as soon as possible and inflate them to the recommended pressure. See Technical specifications.

If this happens frequently, have the cause determined and rectified as soon as possible.

System reset

Note: Do not reset the system when the vehicle is moving.

Note: You should reset the system following any adjustment to the tyre pressures or any changing of tyres.

Note: Turn the ignition on.

Type 2 instrument cluster

1. Using the multifunction lever, navigate to 'SET' > T. Pres.

2. Press and hold the SET/RESET button until the message Tyre Pressure set appears.

Type 3 instrument cluster

1. Using the multifunction lever, navigate to hold 'SET' to set Tyre Pres.

2. Press and hold the SET/RESET button until the message Tyre Pressure set appears.

Using snow chains
WARNINGS: Do not exceed 50 km/h (30 mph). Do not use snow chains on snow-free roads. Only fit snow chains to specified tyres. See Technical specifications. CAUTION: If your vehicle is ...

Technical specifications
Wheel nut torque Tyre pressures (cold tyres) Up to 80 km/h (50 mph) Except convertible, Focus ST and Focus RS Up to 160 km/h (100 mph) 1Only fit snow chains to specified tyres. Continuous ...

More about Ford Focus:

Ford Focus Seat Cushion - Rear
Disassembly NOTE: For component identification and locations, refer to Seat — Exploded View, Rear in this section. Remove the rear seat cushion. Locate the cushion latch releases under the cushion front edge. Push to release the 2 latches and remove the cushion. ...

© 2016-2024 Copyright www.ffguide.net