Ford Focus Service Manual: Valve Spring Strength

Ford Focus Service Manual / Powertrain / Engine / Valvetrain / Valve Actuating Assembly / Valve Spring Strength

Special Tool(s)

Pressure Gauge, Valve/Clutch Spring 303-006 (TOOL-6513-DD) or equivalent

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Use the Valve/Clutch Spring Pressure Gauge to check the valve spring for correct strength at the specified valve spring length.

Valve Spring Installed Length

NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the installed length of each valve spring. ...

Valve Springs

Special Tool(s) Compressor, Valve Spring 303-300 (T87C-6565-A) Compressor, Valve Spring 303-350 (T89P-6565-A) Compressor, Val ...

More about Ford Focus:

Ford Focus Vehicle Certification Label
Base Engine Calibration Information Base engine calibration information, sometimes referred to as the powertrain calibration, is located in the lower right corner of the vehicle certification label. Engine calibration information is limited to a maximum of 5 characters per line (2 lines maxim ...