Ford Focus Service Manual: Window Regulator and Motor - Rear Door

Removal and Installation

1. Remove the rear door speaker. For additional information, refer to Section  415-00.

1. NOTE:

   Do not touch the adhesive surface during removal or installation of the watershield, as re-bonding will be impaired. If additional adhesive is required during installation, apply seam sealer as necessary to completely seal the watershield to the inner door.

   Remove the watershield.

1. Temporarily install the window control switch or the window regulator handle to raise or lower the window to align the regulator clamp with the access hole.

1. Push out the pin and then push out the sleeve of the 2-part spacer.

1. Tape the window glass in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.

1. Disconnect the window regulator motor electrical connector.

1. Remove the 3 window regulator bolts and the window regulator and motor assembly.
   • To install, tighten to 8 Nm (71 lb-in).

1. To install, reverse the removal procedure.