Ford Focus Service Manual: Evaporative Emission Canister Purge Valve
| Item | Part Number | Description |
|---|---|---|
| 1 | 9G683 | Evaporative Emission (EVAP) canister purge valve bracket |
| 2 | 9G641 | EVAP canister purge valve |
| 3 | 14A464 | EVAP canister purge valve electrical connector |
| 4 | — | Vapor jumper tube-to-EVAP canister purge valve quick connect coupling (part of 9D289) |
| 5 | — | Vapor jumper tube-to-EVAP canister purge valve quick connect coupling (part of 9L291) |
| 6 | W709438 | Heat shield retainer (2 required) |
| 7 | — | Heat shield |
Removal and Installation
WARNING: Do not
smoke, carry lighted tobacco or have an open flame of any type when working on or
near any fuel-related component. Highly flammable mixtures are always present and
may be ignited. Failure to follow these instructions may result in serious personal
injury.
WARNING: Do not
carry personal electronic devices such as cell phones, pagers or audio equipment
of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions
may result in serious personal injury.
WARNING: Always
disconnect the battery ground cable at the battery when working on an evaporative
emission (EVAP) system or fuel-related component. Highly flammable mixtures are
always present and may be ignited. Failure to follow these instructions may result
in serious personal injury.
- Disconnect the battery ground cable. For additional information, refer to Section 414-01.
- Remove the 2 retainers and the heat shield.
- Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
- Disconnect the 2 vapor jump tube-to-EVAP canister purge valve quick connect couplings. For additional information, refer to Section 310-00.
- Press the locking tab and remove the EVAP canister purge valve from the bracket.
- To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test in this section.
Evaporative Emission Canister
Item
Part Number
Description
1
—
Vapor tube-to-Evaporative Emission (EVAP) canister quick connect coupling
(part of 9C047)
2
9E857
EVAP ...
Evaporative Emission Canister Vent Solenoid
Item
Part Number
Description
1
9E857
Evaporative Emission (EVAP) canister
2
9F945
EVAP canister vent solenoid
Removal and Installatio ...
More about Ford Focus:
Ford Focus Diagnostic Parameters Identification (PID) Chart
Using Output State Control and Accessing PIDs
To confirm that the output state control value was sent by the scan tool and
the PCM has accepted the output state control substitution, a corresponding PID
or PIDs for each output state control parameter should be monitored. Additional
PIDs shou ...
