Ford Focus Service Manual: Headlamp Assembly - Removal and Installation

Ford Focus Service Manual / Body / Body Electrical / Lighting / Exterior Lighting / Headlamp Assembly - Removal and Installation

Item	Part Number	Description
1	W707594	Headlamp assembly bolts (3 required)
2	13008	Headlamp assembly
3	—	Headlamp assembly electrical connectors (part of 14290)

Removal and Installation

Remove the radiator grille. For additional information, refer to Section 501-08.

NOTE:
There is a blind metal snap located on the lower outboard side of the headlamp assembly that is disengaged by pulling upwards on the headlamp assembly.
Remove the 3 bolts and the headlamp assembly.
- Disconnect the electrical connectors.

To install, reverse the removal procedure.
- If necessary, adjust the headlamps. For additional information, refer to Headlamp Adjustment in this section.

Headlamp Adjustment - General Procedures

Special Tool(s) Vision 100 Photometric Headlamp Aimer 196-00005 or equivalent Aiming Methods NOTE: Refer to the Owners Literature for the headlamp adjustment screw ...

Headlamp Switch - Removal and Installation

Item Part Number Description 1 11654 Headlamp switch 2 — Headlamp switch electrical connector (part of 14401) Removal and Installat ...

More about Ford Focus:

Ford Focus Accessory Drive Belt Idler Pulley
Removal and Installation With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. Remove the 2 bolts and accessory drive belt splash shield. To install, tighten to 9 Nm (80 lb-in). Using the hex feature, rotate ...