Ford Focus Service Manual: Steering Wheel Wrap Bonding
| Item | Specification |
|---|---|
| Instant Gel Adhesive TA-19 | WSK-M2G402-A4 |
- NOTE:
If re-adhering leather to the front side of the steering wheel only, it will not be necessary to remove the steering wheel. Steering wheel removal is necessary only when repairing loose leather on the backside of the steering wheel.
If necessary remove the steering wheel. For additional information, refer to Steering Wheel in this section.
- Position the loose leather out of the way.
- Apply the specificed adhesive evenly over the wheel spoke.
- Position the loose leather back into the original position.
- NOTE:
The adhesive should be completely set after 5 minutes. Do not pull on the repair area.
Smooth the leather and tuck in for neat appearance.
- Apply pressure (for at least 30 seconds) until the leather is bonded to the wheel spoke.
- If removed, Install the steering wheel. For additional information, refer to Steering Wheel in this section.
Steering Wheel Rotation Sensor
Special Tool(s)
Vehicle Communication Module (VCM) and Integrated Diagnostic System
(IDS) software with appropriate hardware, or equivalent scan tool
...
Suspension
...
More about Ford Focus:
Ford Focus Cylinder Bore Taper
NOTE: Refer to the appropriate Section 303-01 for the specification.
Measure the cylinder bore at the top, middle and bottom of piston ring travel
in 2 directions as indicated. Verify the cylinder bore is within the wear limit.
The difference indicates the cylinder bore taper. If the cyl ...