Ford Focus manuals

Ford Focus Service Manual: Wiper Pivot Arm

Removal and Installation

  1. Lift up the covers and loosen the wiper pivot arm nuts approximately 2 turns.
  1. Lift the wiper pivot arms and release them from the taper by moving them to one side.
  1. Remove the nuts and wiper pivot arms.
    • To install, tighten to 27 Nm (20 lb-ft).
  1. To install, reverse the removal procedure.
Wiper Mounting Arm and Pivot Shaft
Removal and Installation Remove the cowl panel grille. For additional information, refer to Section  501-02. Remove the cowl panel support brace. Disconnect the winds ...

Wiper Motor
Removal and Installation NOTE: A new wiper motor assembly comes with the linkage arm installed. Remove the wiper mounting arm and pivot shaft. For additional information, refer to Wiper Mou ...

More about Ford Focus:

Ford Focus Direct Clutch
Special Tool(s) Compressor, Spring Washer 307-209 Dial Indicator Gauge With Holding Fixture 100-002 (TOOL-4201-C) Material Item Specification Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC (US); ...

© 2016-2020 Copyright www.ffguide.net