Ford Focus Service Manual: Blower Motor Resistor
| Item | Part Number | Description |
|---|---|---|
| 1 | — | Blower motor resistor electrical connector (part of 18B604) |
| 2 | 18591 | Blower motor resistor |
Removal and Installation
- Lower the glove compartment.
- Disconnect the blower motor resistor electrical connector.
- NOTE:
To detach the blower motor resistor from the housing, slide the resistor to the right and lift upward.
Detach and remove the blower motor resistor.
- NOTE:
The blower motor resistor is not equipped from the factory with a mounting screw. A backup screw boss is provided where a screw can be installed if the blower motor resistor does not clip securely to the heater core and evaporator core housing.
To install, reverse the removal procedure.
Blower Motor
Item
Part Number
Description
1
—
Blower motor electrical connector (part of 14401)
2
—
Blower motor screw (3 required)
3
198 ...
Heating
...
More about Ford Focus:
Ford Focus Reference Value Parameter Identification (PID)/Measured Signal Chart
The following listing reflects PIDS and/or measured values which may reveal a
possible concern within each system shown. Match the category number with the related
PID/measured signal and go to the Typical Diagnostic Reference Value Charts.
PID/Measured Signal Chart
Category Numbe ...
