Ford Focus Service Manual: Child Safety Seat Tether Anchor

Item	Part Number	Description
1	613D74	Center child safety seat tether anchor
2	W705708	Child safety seat tether anchor bolt
3	613E54	Center child safety seat tether anchor trim cover

Removal and Installation

WARNING: After
any crash, all of the following safety belt assemblies and attaching hardware must be inspected to verify correct function:

• Retractors
• Buckles
• Belt tension sensor (BTS) (if equipped)
• Front safety belt buckle support assemblies (slide bar) (if equipped)
• Safety belt shoulder belt height adjusters (if equipped)
• Child safety seat tether bracket assemblies
• Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)

If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion of this section, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.

After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.

WARNING: Always
tighten the child safety seat tether anchor/bolt to specification. Failure to follow this instruction may result in the child's safety seat being incorrectly secured, which increases the risk of serious personal injury or death to the child in a sudden stop or crash.

NOTE:

The outboard child safety seat tether anchors are welded to the parcel shelf. Only the center tether anchor is bolted to the parcel shelf and is serviceable.

1. Remove the center child safety seat tether anchor trim cover.

1. Remove the bolt and child safety seat tether anchor.
   • To install, tighten to 30 Nm (22 lb-ft).

1. To install, reverse the removal procedure.