Ford Focus Service Manual: Connecting Rod Bearing Journal Taper and Out-of-Round

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Connecting Rod Bearing Journal Taper and Out-of-Round

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Measure the crankshaft connecting rod journal diameters in 2 directions perpendicular to one another at each end of the connecting rod journal. The difference in the measurements from one end to the other is the taper. Verify measurement is within the wear limit.

Connecting Rod Twist

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Using the Feeler Gauge ...

Connecting Rod Bearing Journal-to-Bearing Clearance

NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: The crankshaft connecting rod journals must be within specifications to check the connecting rod bearing journal clearan ...

More about Ford Focus:

Ford Focus Removing a rear lamp
3-door and 5-door 1. Open the luggage compartment lid. 2. Remove the screws. 3. Disconnect the electrical connectors. 4. Remove the rear lamp. Estate 1. Open the luggage compartment lid. 2. Remove the screws. 3. Disconnect the electrical connector. 4. Remove the rear lamp. Conv ...

Nissan Frontier - Instrument Panel - Keys - Brake system