Ford Focus Service Manual: Connecting Rod Twist

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Connecting Rod Twist

Special Tool(s)

Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Using the Feeler Gauge Set, measure the connecting rod twist on a suitable alignment fixture. Follow the instructions of the fixture manufacturer. Verify the measurement is within specification.

Connecting Rod Large End Bore

NOTE: Refer to the appropriate Section 303-01 for the specification. Tighten the bolts to specification, then measure the bore in 2 directions. The difference is the connecting rod bore out-o ...

Connecting Rod Bearing Journal Taper and Out-of-Round

NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the crankshaft connecting rod journal diameters in 2 directions perpendicular to one another at each end of the co ...

More about Ford Focus:

Ford Focus Quarter Trim Panel - 4-Door
Removal and Installation Remove the D-pillar trim panel. For additional information, refer to D-Pillar Trim Panel in this section. Remove the rear seat bolster. For additional information, refer to Section 501-10. Remove the safety belt lower anchor. To install, ...